tag:blogger.com,1999:blog-4567382598724166625.post3084506867991648446..comments2023-12-20T13:32:48.209+02:00Comments on CCIE in 3 months - Is it possible?: Storm-control differences between 6500/7600 and other switchesTassoshttp://www.blogger.com/profile/04512662084752743003noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-4567382598724166625.post-44655564101364817592009-05-28T23:37:45.568+03:002009-05-28T23:37:45.568+03:00Jimmy, that would be only for the port under which...Jimmy, that would be only for the port under which is configured.Tassoshttps://www.blogger.com/profile/04512662084752743003noreply@blogger.comtag:blogger.com,1999:blog-4567382598724166625.post-16863720127223889872009-05-28T22:27:31.264+03:002009-05-28T22:27:31.264+03:00Would it block broadcasts per vlan or for the whol...Would it block broadcasts per vlan or for the whole switch ?Jimmyhttps://www.blogger.com/profile/17522131753770601839noreply@blogger.comtag:blogger.com,1999:blog-4567382598724166625.post-62179398255892507962009-02-24T02:39:00.000+02:002009-02-24T02:39:00.000+02:00Shivlu, if you check the dotted lines on the above...Shivlu, if you check the dotted lines on the above diagrams, you can clearly see the difference.<BR/><BR/>From T1 to T2 there is a 1" interval.<BR/><BR/>3750 : when the threshold is exceeded during the T1-T2 interval, nothing happens. Instead, storm-control is activated on the next interval T2-T3 and lasts (in 1 sec steps) until broadcast traffic goes below threshold.<BR/><BR/>6500 : when the Tassoshttps://www.blogger.com/profile/04512662084752743003noreply@blogger.comtag:blogger.com,1999:blog-4567382598724166625.post-64611311038498495712009-02-16T18:26:00.000+02:002009-02-16T18:26:00.000+02:00i am not clear between the differences. Can you el...i am not clear between the differences. Can you elaborate it more or post some doc for the same.<BR/><BR/>regards<BR/>shivlu jainShivlu Jainhttps://www.blogger.com/profile/18067647693954733854noreply@blogger.com